Egton High Moor: Cycling Climb

The climb · United Kingdom

About Egton High Moor

Collections

Simon Warren’s Another 100 Greatest Cycling Climbs

Egton High Moor climbs south-west from Egton Bridge, leaving the Esk valley on the road towards Rosedale. The ascent stretches for about 6.7 kilometres, but the opening makes a much sharper demand than that length and a gentle overall average might suggest. Trees and a tight bend frame the lower climb, where the road gains height rapidly. This first passage establishes the effort before the moorland continuation begins to show a less severe side.

Once above the steeper slopes, the gradient eases and the surroundings open out. The road still has a long way to run, with small changes in height interrupting the gentler upland stretches. Exposure can make the wind as noticeable as the slope, giving the later road a different feel from the enclosed ascent below. Egton High Moor is memorable for that transition: concentrated climbing out of the valley, followed by an extended passage across higher, more open ground.

01 / The ascent

Elevation profile

Start 54 m · Summit 323 m

Gradient by distance6.74 km / 291 m gain

0 km1.3 km2.7 km4 km5.4 km6.7 km

02 / The crux

Where it gets difficult

Choose a distance to find the steepest continuous section of the climb.

Steepest 500 m average

14.1%

Where to find it

0.60–1.10 km from start

Net height gained: 70 m
Section length: 500 m

The whole climb6.72 km

0 kmFinish

03 / The numbers

Climb statistics

Distance: 6.74 km
Elevation gain: 291 m
Average gradient: 4.0%
Climb category: 3
Start elevation: 54 m
Summit elevation: 323 m

Current weather

At the climb start

Loading weather…

Weather data: MET Norway

04 / Your effort

How long would it take?

Enter the power you could hold for the whole climb. We calculate a moving time from the elevation profile and the forces you ride against.

Sustained power

W/kg

Use your intended climbing effort, rather than FTP unless you can hold it for the predicted duration.

Rider weight (kg)

Bike + kit weight (kg)

Bike + kit includes clothing, bottles and luggage.

Advanced settings

Defaults represent a road-bike scenario. Adjust these settings to match your tyres, drivetrain and riding position.

Effective drag area (CdA) (m²)

Rolling resistance (Crr)

Drivetrain efficiency (%)

Modelled moving time

24 min

Power throughout: 225 W
Average speed: 16.7 km/h

Based on the 6.72 km elevation profile. Assumes steady power, with no stops, braking or drafting. Rounded to the nearest minute.

The science behind the calculation

For each part of the stored profile, we solve the steady-state cycling power equation for speed, then add distance ÷ speed across the climb. Gravity uses rider + equipment weight; available power is W/kg × rider weight. This uses the profile’s distance and elevation together, without mixing in another route’s metrics.

Power × efficiency = gravity + rolling resistance + air resistance + bearing losses

The resistance equations are adapted from Martin et al. (1998), Validation of a Mathematical Model for Road Cycling Power. Air density changes with profile altitude using NASA’s standard-atmosphere model. This calculator’s adaptation has not been independently validated.

It predicts travel at the power you enter, including on descents. It does not model acceleration, cornering, braking, traffic, wind, changing weather or fatigue. At altitude, choose power you can sustain there: thinner air reduces drag, but this model does not predict its effect on your ability to produce power. Profile quality and assumed equipment settings also affect the result.

05 / On the ground